SenSafe Iron Test Strips

Has a detection sensitivity of 0.1 ppm (mg/L) on the Iron Check test strip. This test promises to be an attractive alternative to wet chemical iron tests for several reasons: There are no hazardous chemicals to mix (an MSDS is not required); Quick results are obtained in minutes; And, best of all, the Total Iron Test Strips are safe and easy to use for fast accurate results within the ranges of 0.0 to 5 ppm (mg/L-ppm), which permits the measurement of the typical iron levels found in well, tap, lake and creek and stream water. The testing is easy: dip the test strip into a sample for 30 seconds with a constant back and forth motion, remove, and match the color to the chart on the bottle after 2 minutes to quantify the Total Iron level in the sample.

Total Test Time:
2 Minutes, 30 Seconds